AED 11.55
1
Description
-
This module apply for stepper motors.One dirver drives 2 motors.
Suitable for mini printer and low current motor.
- Run 2 motors off 1 stepper driver
- Parallel wiring
- Compatible with EZBoard, Creality Boards, MKS Gen L, SKR and many others that use a standard 4 pin JST connection
Installation
- Simply plug one end of the included cable to your printer Z motor connection.
- Plug the other end into any of the 3 4 pin plugs on the Adapter board
- Plug your 2 motors into the 2 remaining open posts on the adapter board
- check that the axis moves smoothly. If it does not then increase the VREF by 0.1V until the axis moves smoothly
- Secure the board so that it cannot short out anything. Wrap with electrical tape or print the case below.
- Printable Case for the board: Click Here
- you can view the case using this online viewer: Just Click Here
Packing List:
module
Cable