Tags: GSM, GPRS, SIM900, 1800MHZ, SMS, MODULE, M590,

GSM GPRS 1800MHZ SMS MODULE M590

  • 69.00 AED
    • Ex Tax:69.00 AED
    • Product Code: M590
    • Availability: In Stock
    SIM900 Module GSM GPRS 900 1800 MHz Short Message Service SMS module noway m590 for Arduino remote sensingDescription:M590 pure data communication module is an ultra-compact GSM/GPRS industrial wireless module, optional Dual-band or Quad band. It provides high-quality SMS, GPRS data connection for u..

      SIM900 Module GSM GPRS 900 1800 MHz Short Message Service SMS module noway m590 for Arduino remote sensing

      Description:

      M590 pure data communication module is an ultra-compact GSM/GPRS industrial wireless module, optional Dual-band or Quad band. It provides high-quality SMS, GPRS data connection for use in industrial and commercial fields.

      Feature: 

      • Dual-Band 900/ 1800 MHz
      • The computer serial port control to send and receive messages, send and receive GPRS data
      • The single-chip microcomputer control to send and receive messages, send and receive GPRS data
      • The telephone type (no voice part can't talk)
      • Ringing output
      • Working voltage: 3.7-4.2V
      • The default baud rate: 115200

      Recommendation:

      All modules are pretested before shipping. We recommend to use a USB to RS232 to connect to the GSM/GPRS module. 

      Downloads:

      standard AT instruction set (a very easy way to command&control the modem)

        integrated support of TCP/IP, HTTP GET/POST, FTP and UDP data transfer protocols

          low energy consumption (measured virtually zero wattage with 3.2 mA at 3.9 V, and 180 mA peaks during SMS sending)

          accommodate any SIM card size (with a card adapter)

          Firstly connect the grounds together and connect 5V to it (some voltage drop from the diode gets it to about what the spec wants, 3.3 - 4.5).


          I also hooked it up to a FTDI breakout board so I could send and receive serial data (3.3V TX and RX).


          I was just using the serial monitor within the Arduino IDE.  Set it to 57600 baud and also set the line ending to be a "Carriage Return" or "Both NL & CR".

          Ground the BOOT pin momentarily to make it boot.  The boot LED flashed on and off steadily.

          In the serial console it displays "MODEM:STARTUP" then eventually also displays "+PBREADY".

          E.g.

          MODEM:STARTUP
          
          +PBREADY
          

          At this point you can issue some basic AT commands to get some info about the module and SIM Card.

          To get the IMEI number issue the command :AT+CGSN and it will respond with the IMEI and OK.  I changed the IMEI here so as to not show my actual IMEI

          AT+CGSN
          
          358510000000000
          
          OK

           The command ATI will display info about the module

          ATI
          
          NEOWAY
          M590
          REVISION 01.30b
          
          OK

          This thing wouldn't register the SIM on the network and upon further reading .. GAME OVER!

          I live in USA and no carrier supports the 900MHz and 1800MHz frequencies that this module operates at! :)

          Look at this map and you can see that you can use these modules in pretty much the WHOLE WORLD except for North America and most of South America :(


          DataSheet Of GSM M590  Module: Click HERE


          There are no reviews for this product.

          Write a review

          Please login or register to review